To position each image, a printer needs to locate the next label. The physical reference on the roll must match the sensing method. Choose it from the actual media, not simply its colour.
Inspect the media
On die-cut labels, the space between labels generally exposes the liner. Other supplies use a notch or a black mark on the reverse. Unwind a few units to identify the reference and its repetition. Do not mistake decorative printing for a sensing mark.
Select the correct mode
Menus may use gap, web, notch, black mark or continuous. Terminology depends on the machine. Consult the manual for the option matching your media; do not choose continuous merely to suppress a paper error.
Position the sensor when required
For a movable sensor, follow the manufacturer’s placement instructions and the mark’s path. Some sensors or positions do not support every sensing mode. A mark outside the reading area will not be detected correctly.
Check the driver too
Software may send its own settings to the printer. Keep the document, driver and printer-panel settings consistent. After changing media, perform the prescribed calibration and test a small batch.
Prepare replacement orders
Keep photographs of both sides, reference-mark position, dimensions and full machine model. An equal-sized roll with a different mark may need a different setup or be unsuitable for the printer. Confirm this before ordering.
Match your supplies to the application
Explore SEGO's consumables range. To check a reference, send us the dimensions and exact machine model.
Technical documentation : read the manufacturer’s guidance.