Label printer skipping labels: causes and solutions

Categories : Default
star
star
star
star
star

Does your printer feed two labels when you requested one, or start printing halfway down the label? Skipping does not automatically mean the roll is faulty. First separate a media-detection problem from a document-layout problem.

1. Observe the fault before changing settings

Stop the batch and keep a few failed prints. Record whether the shift is constant, grows along the roll or appeared immediately after a roll change. A repeatable fault is easier to diagnose than a print job restarted after several settings have been changed together.

Use the media-feed function described in the manual. If the roll consistently stops at the same position, investigate the document size and driver settings first. If feeding is irregular, check loading and media detection.

2. Check the sensing method

A printer may detect the gap between labels, a notch or a black mark. The setting must match the actual media. Continuous mode is intended for continuous stock; it is not a substitute for sensing die-cut labels. Some drivers can also override printer settings whenever a job is sent.

3. Reload and calibrate

Check that the roll turns freely, the guides hold the backing without squeezing it and the sensor is positioned as instructed in the manual. Then run the calibration procedure for your exact model so the printer can recognise the media. Avoid button combinations intended for a different machine.

4. Check the label template

The document width and height must match the label. Label height is different from pitch, which includes the space to the next label. Also check orientation and margins. Print five identical samples before restarting production.

When should you request help?

If the fault persists with a previously approved roll, send technical support the exact printer model, a photograph of the media path, the consumable dimensions and your test prints. This makes diagnosis more useful than ordering another reference at random.

Is calibration needed after every roll change?

Follow the manufacturer's recommendations. Changes in size, material or sensing method are particularly good reasons to check calibration.

Browse SEGO's label range or contact our team with the reference you currently use.

Technical reference: Zebra — media sensors and driver settings. Procedures vary by model.

Share this content

Please log in to rate this article